Author Topic: Painless wiper switch install  (Read 1014 times)

Offline cudasteve72

  • Jr. Member
  • **
  • Posts: 319
Painless wiper switch install
« on: March 07, 2020 - 12:19:19 PM »
So I am trying to wire my wiper motor.  It is a 2 speed motor, I have a painless harness in the car.  the painless harness gives me  the B+ wire in the harness, then I have the brown red blue and green wires coming off of the wiper motor.  That is where the help is needed.I am using the painless 80173 2 speed wiper switch.  The switch has terminals B, w, 1,2,3  I know B is battery power which is the wire I have from my harness but what and where do the wires from the motor come from.  please help.
1972 Cuda Custom 70 clone  416 stroker 481/531 hp/
2006 Grand Cherokee SRT8 (daily)
1970 Challenger convertible 340 (Dad's)
1967 Dart gt slant six all original 40,000 miles driver but needs restoration (Brother's)
2011 Jeep Grand Cherokee (wife's)




Offline 70chall440

  • Sr. Resident
  • ******
  • Posts: 6141
Re: Painless wiper switch install
« Reply #1 on: March 07, 2020 - 03:32:42 PM »
I am not sure if this is going to be helpful or now, but you need to bench test the wiper and switch until you get it figured out. This drawing is for a normal E body 3 speed switch.
Current Mopar
70 Challenger RT 440-6 EFI, 73 Cuda 416-6 EFI
05 Hemi Durango, 01 Ram 4x4, 14 Ram 2500 4X4, 10 PCP Challenger 6 spd RT, 01 Viper GTS ACR, 52 B3B w/330 Desoto Hemi, 70 Hemi RR (under const)
Past Mopars
9 x Challengers. AAR Cuda, 4 RR, 2 GTX, 4 Chargers, etc... (too many to list)